WLH2 Classe
Manual
Page 32 – Revision: 3-2-2021
PRE-INSTALLATION PROCEDURES
DANGER!
ELECTRICAL SHOCK HAZARD.
Only qualified personnel who have read and understand this entire manual should
attempt to install, or service this
WLH2 Classe
, failure to do so could result in death or
serious injury. DO NOT plug into an electrical supply until specifically instructed.
CAUTION!
DRIP TRAY DRAIN.
If you intend to provide a drip tray drain for your customer, be aware that you will be
called multiple times per month to service and unclog the tubing leading away from the
drip tray to drain. Users will clog the drain with paper clips, erasers, napkins, tea bags,
gum, and various other intended items. Waterlogic recommends you establish a
minimum of weekly visits to the machine for cleaning of the drip tray drain.
WARNING!
USE PROPER PERSONAL PROTECTIVE EQUIPMENT
Always ensure proper ventilation and use proper personal protective equipment such as
gloves and eye protection when using chemicals. Refer to Material Safety Data Sheet for
specific requirements of each chemical product. Take all necessary precautions to
prevent sanitizer from contacting eyes, clothing, and any other surfaces in could damage
(carpets).
DANGER!
ELECTRICAL SHOCK HAZARD.
Do not plug in unit unless qualified. Only qualified personnel who have read and
understand this entire manual should attempt to install or service this unit.
1.
Remove the
WLH2 Classe
from the box, and place on the countertop or surface where it
will be operated. Remove all cellophane wrapping from the machine. Perform a visual
inspection of the unit for any damage or missing pieces.
2.
Open the drip tray, remove the power cord and any accessories. Remove all cellophane
wrapping, reassemble the drip tray and return to its position on the drip tray shelf.
3.
Once the machine is in the desired position, lock the rolling wheels installed on the
bottom of the machine to keep it in place. Do not install on an inclined surface.
4.
Remove the bulkhead caps on the top two bulkhead connectors at the rear of the
machine.
