Replacement instructions for H2O-F45:
Step 1:
Turn off incoming water supply to the filtration unit.
Step 2:
Open the cold water faucet handle to relieve the water
pressure.
Step 3:
Remove filter from lid by turning it to the left, then pull
the filter down out of the lid. Discard the old filter.
Step 4:
Remove plastic wrapping and cap from new filter.
Step 5:
To install new filter cartridge, with the filter label facing
approximately 45 degrees to the left, push the filter into
the lid and twist it to the right until the filter locks in and
the label on filter is facing the front.
Step 6:
Follow start-up procedure. Turn-on water supply at
cold water angle stop. Turn cold water faucet handle to
the open position to start the flow of water through the
unit. Run 5 gallons of water through the unit in order to
flush out the normal black carbon fines (it will “sputter”
until the air is purged out) from the unit. A container
with a known volume can be filled to determine how
much water has flushed through the system. Initially,
the water may appear cloudy which is due to tiny air
bubbles and it will clear up shortly. Close the faucet
when finished.
Step 7:
Check for leaks. If you have any leaks, shut off the
water supply to your system, tighten any fittings then
turn the water back on. Check frequently over the next
24 hours to ensure no leaks are present. If you have
any questions, please call our retail customer service at
(888)321-0500
.
Filter Replacement Instructions
Where Used:
Model number /
Watts Part Number
Model / Watts
Part Number
Change time frame
H2O-F45 / 88005232
H20-DWCB100 /
88005231
No more than 12 months or
10,000 gallons for chlorine from
installation date
High Capacity Quick Turn Carbon
Filter: H2O-F45
Replacement filter for Watts Pure H20 High
Capacity Carbon Block Filtration System,
H20-DWCB100
Parts Included:
H2O-F45 Replacement Filter
Operating Specifications:
Flow Rate: 1.5 GPM (5.7 LPM)
Temperature Range: 40 – 100°F (4.4 – 37.8°C)
Pressure Range: 10 – 125 psi (69 – 862 kPa)
WARNING
!
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
CAUTION
!
Use PureH2O replacement cartridge only. Other filters may look the
same, but H2O-F45 filters by PureH2O are manufactured to fit your
H2O-DWCB100 filter unit in order to ensure proper reduction of
water contaminants.
IMPORTANT
If you are unsure about installing your WATTS water filter, contact a
WATTS representative or consult a professional plumber.
Component tested and certified by WQA
against NSF/ANSI Standard 372 for “lead free”
compliance. Refer the receiving system’s
Installation and operational manual for specific
reduction claims and performance data.
Step 5-2
Step 5-1
Step 4
Step 3
Tubing not shown in above pictures. Do not remove the tubings
while changing the filter
NOTICE
COMPONENT
