A S S E M B LY I N S T R U C T I O N
C A N T I L E V E R U M B R E L L A - B A S E P L A T E
Scope of delivery:
1 x cantilever umbrella, 1 x adapter, 2 x cylinder head screw M8x25 mm, 1 x 2.5 mm
Allen key, 1 x 6 mm Allen key, 1 x crank mechanism, (4 x countersunk screw M8x20 mm as an alternative
to the 4 countersunk screws M8x25mm, included with the base plate)
Mount the adapter on the cantilever umbrella base plate as described in the assembly instructions
"Screw-on sleeve for cantilever umbrella."
Remove the cantilever umbrella from its packaging and place it on the adapter. (Umbrella canopy must
be on the same side as the adapter foot pedal).
Screw the umbrella pole to the adapter using the 2 cylinder head screws. You will need the 6 mm Allen
key to do this.
Now fit the crank mechanism and tighten with the 2.5 mm Allen key.
Putting up the umbrella:
Step 1: Release the hand wheel at the umbrella pole.
Step 2: Crank the umbrella canopy into extended position.
(The locking slide automatically moves upward as you do so).
Step 3: Set the umbrella canopy to the desired angle and lock the hand wheel in position.
The umbrella can be rotated around its own axis using the adapter foot pedal.
1
2
4
3
6
7
5
