Wheelock PS-11A, Installation Instructions

P80945 N 

Sheet 1 of 3 

273 Branchport Ave. 
Long 

Branch, 

NJ 

07740 

Thank you for using our products.

(800)  631-2148 
www.wheeelockinc.com 

INSTALLATION INSTRUCTIONS 

TELSTROBE 

Use this product according to this instruction manual.  Please keep this instruction manual for future reference. 

MODEL:  PS-11A 

APPLICATION INFORMATION: 

Wheelock Inc. manufactures high quality telephone products.  The installation of this product must conform to the following 
instructions.  IF ANY WORDS OR LETTERS APPEAR ON THE PRODUCT INDICATING A PARTICULAR USE, THE 
PRODUCT MUST BE USED ONLY IN THE MANNER SO INDICATED.  THE INSTALLATION OF THIS EQUIPMENT 
SHOULD ONLY BE UNDERTAKEN BY QUALIFIED PERSONNEL.  FIELD ADJUSTMENT, REPAIR OR MODIFICATION 
OF THESE SIGNALS SHOULD NOT BE ATTEMPTED.  Malfunctioning units should be returned for factory repair or replacement 
in accordance with Wheelock Inc.'s published terms and conditions.  Contact Wheelock Inc., 273 Branchport Ave., Long Branch, NJ, 
07740. 

NOTE:

  All 

CAUTIONS

 and 

WARNINGS

 are identified by the symbol 

.  All warnings are printed in bold capital letters. 

WARNING:  THE TELSTROBE IS NOT TO BE USED AS AN INDOOR VISUAL EVACUATION SIGNAL FOR THE 
HEARING IMPAIRED. 

FCC REGULATIONS: 

- 

This equipment complies with Part 68 of the FCC Rules.  The label affixed to this product contains, among other information, 
the FCC Registration Number and the Ringer Equivalence Number (REN) for this product.  This information must be provided 
to the telephone company if requested. 

- 

The REN is used to determine the quantity of devices which you may connect to your telephone line and still have all of those 
devices ring when your telephone number is called.  In most, but not all areas, the sum of the REN's of all devices connected to 
one line should not exceed five (5.0).  To be certain of the number of devices that you may connect to your line, contact your 
local telephone company. 

- 

This equipment should not be used on coin telephone lines.  Connection to party line service is subject to state tariffs. 

- 

If trouble is experienced, disconnect this equipment from the telephone line to determine if it is causing the malfunction.  If the 
equipment is determined to be malfunctioning, its use shall be discontinued until the problem has been corrected. 

- 

Should the equipment cause harm to the telephone network, the telephone company shall, if possible, notify the customer that 
temporary discontinuance of service may be required; however, where prior written notice is not possible, the telephone 
company may temporarily discontinue service without notice, if such action is necessary under the circumstances.  The 
telephone company may make changes in its communication facilities, equipment and operations procedures, where such action 
is reasonably required in the operation of its business and is not inconsistent with the rules and regulations of the Federal 
Communications Commission. 

DOC REGULATIONS: 

NOTICE:  The Canadian Department of Communications label identifies certified equipment.  This certification means that the 
equipment meets certain telecommunications network protective operational and safety requirements.  The Department does not 
guarantee the equipment will operate to the user's satisfaction. 

- 

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local 
telecommunications company.  The equipment must also be installed using an acceptable method of connection.  In some cases, 
the company's inside wiring associated with a single line individual service may be extended by means of a certified connector 
assembly (telephone extension cord).  The customer should be aware that compliance with the above conditions may not prevent 
degradation of service in some situations. 

- 

Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications 
company cause to request the user to disconnect the equipment. 

- 

Make sure that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if 
present, are connected together. 

CAUTION:

  The installation of this equipment should only be undertaken by qualified personnel. 

Copyright 1998 Wheelock, Inc.  All rights reserved.