Page 1
©2012 Whelen Engineering Company Inc.
Form No.14616 (091212)
Installation Guide:
Dominator™ mounting bracket
Model DBKT6 / 2012 Tahoe Hatchback
®
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet:
www.whelen.com
Sales e-mail:
autosale@whelen.com
Canadian Sales e-mail:
canadiansales@whelen.com
Customer Service e-mail:
custserv@whelen.com
For warranty information regarding this product, visit
www.whelen.com/warranty
Automotive:
Lightbars
Installation:
This bracket mounts to the
rear window latch housing.
1. Remove the end cap on
the Dominator™ and add a
fourth carriage bolt, then
replace the end cap (Fig.
3).
2. Remove the 2 existing
christmas tree plugs on
either side of the window
latch and install 2 rivnuts.
3. Install the bracket onto the
vehicle and install the
Dominator™ lightbar onto the bracket using the supplied mounting hardware (Figs. 2 & 4).
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this
product will not interfere with or compromise the operation or efficiency of any vehicle equipment. Before returning the
vehicle to active service, visually confirm the proper operation of this product, as well as all vehicle components/equipment.
©2012 Whelen Engineering Company Inc.
Form No.14616 (091212)
Installation Guide:
Dominator™ mounting bracket
Model DBKT6 / 2012 Tahoe Hatchback
®
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet:
www.whelen.com
Sales e-mail:
autosale@whelen.com
Canadian Sales e-mail:
canadiansales@whelen.com
Customer Service e-mail:
custserv@whelen.com
For warranty information regarding this product, visit
www.whelen.com/warranty
Automotive:
Lightbars
Installation:
This bracket mounts to the
rear window latch housing.
1. Remove the end cap on
the Dominator™ and add a
fourth carriage bolt, then
replace the end cap (Fig.
3).
2. Remove the 2 existing
christmas tree plugs on
either side of the window
latch and install 2 rivnuts.
3. Install the bracket onto the
vehicle and install the
Dominator™ lightbar onto the bracket using the supplied mounting hardware (Figs. 2 & 4).
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this
product will not interfere with or compromise the operation or efficiency of any vehicle equipment. Before returning the
vehicle to active service, visually confirm the proper operation of this product, as well as all vehicle components/equipment.
