If there are two clamp spindles included with the Toggle Clamp
(6305)
, remove the shorter spindle and replace it with the
longer spindle. For quicker spindle adjustments, replace the top
nut on the spindle with the thumb nut
(5525)
.
Install two nylon washers
(WN002)
on each of the 1" screws
(5772B)
, insert the screws thru the two front Toggle Clamp
mounting holes. Slide the Clamp Pad
(6305B)
on to
the 1" screws
(position threaded hole in clamp pad at
rear of toggle clamp)
and start an oval nut
(5765B -
raised side first)
, on the end of each screw.
6305IC
Inboard Clamp
Owners Manual
Please Read Carefully!
BEFORE BEGINNING
Identify and verify that you have all the parts
listed. Read the instructions at least once, familiarizing
yourself with the parts before beginning. You'll
need a #3 Phillips screwdriver for assembly.
Attach the clamp pad to the rear of the
Toggle Clamp using the 3/8" screw
(MP375)
.
Slide the Toggle Clamp/offset oval
nuts on to the selected T-slot(s) of the
Ultra Track, position where desired
and tighten the two 1" screws.
Parts List:
Part
Description
Quantity
6305
Toggle Clamp . . . . . . . . . . . . . . . . . . . . . . . . .1
6305ICH Clamp Hardware below:
WN002
Nylon Washer . . . . . . . . . . . . . . . . . . . . . . . . .4
5765B
Oval Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
5772B
1" Screw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
MP375
3/8" Screw . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
5525
Thumb Nut . . . . . . . . . . . . . . . . . . . . . . . . . . .1
6305B
Clamp Pad . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
5772B x2
WN002 x4
5765B x2
MP375
1
