background image

SETUP INSTRUCTONS

SETUP INSTRUCTONS

Connect the AC power cord to 
the USB charger. Connect the 
AC power cord to a 100-240 
VAC power source.  

Note: The USB charger may 
also be used to connect the 
charging cables for KUBI and 
the tablet.  

Plug the 3.5 mm side connector 
on the microphone into the 
earphone port on the tablet. 
Rotate the microphone so it 
points the same direction as the 
tablet screen. 

Plug one end of the  audio cable 
into the earphone port on the 
end of the microphone. 

Plug the other end of the audio 
cable into the AUDIO IN port on 
the speaker.

Plug the mini USB cable into 
the DC IN port on the speaker.  

Connect the other end of the 
USB cable into one of the ports 
on the USB charger.  

Turn the speaker power switch 
to ON

Play an audio file on the tablet 
and adjust speaker volume 
using the tablet’s volume con-
trol buttons. 

kubi

Enhanced Audio Kit

Copyright © 2017 Xandex Inc. 1360 Redwood Way, Suite A, Petaluma CA 94954     

TEL: (707) 763-7799  EMAIL: kubi@xandex.com For more infomation visit www.revolverobotics.com  P/N 180-0135r1                


Summary of Contents for Kubi Enhanced Audio Kit

Page 1: ...audio cable into the earphone port on the end of the microphone Plug the other end of the audio cable into the AUDIO IN port on the speaker Plug the mini USB cable into the DC IN port on the speaker Connect the other end of the USB cable into one of the ports on the USB charger Turn the speaker power switch to ON Play an audio file on the tablet and adjust speaker volume using the tablet s volume ...

Page 2: ...ver the thread ed insert on the kubi Orient the speaker bracket over the arm as shown and install one of the small center pin torx screws using the kubi wrench Wrench and screws are supplied with the kubi not the audio kit Slide the left arm into place behind the speaker bracket and align the flat edge to the flat edge on the right arm red arrow in image 2 Rotate the speaker bracket down into plac...

Page 3: ...etal washer Keep downward pressure on the arm and place the audio speaker bracket over the right arm bushing and install the retaining screw Tighten so the bracket can still be rotated Remove the left arm screw and metal washer Rotate the bracket down and install the left screw Tighten both screws After installation of the bracket the arms should be retracted in upright position If arms do not mov...

Page 4: ...rd pressure on the arm and carefully remove the washer Replace the washer with one of the supplied white nylon bush ings Place the audio speaker brack et over the right arm bushing and install the retaining screw Tighten so the bracket can still be rotated Remove the left arm screw and washer and install a white nylon bushing Rotate the bracket down and install the left screw Tighten both screws I...

Reviews: