XENA SECURITY XX SERIES BLE DISC-LOCK ALARM QUICK START GUIDE
Questions or comments about your XENA product? Email us at info@xenasecurity.com
What’s in the box:
1.
Key barrel
2.
Locking pin
3.
Battery cover
4.
CR2 Lithium Battery (supplied)
5.
Alarm module
6.
Reflector
7.
Spring-loaded catch
8.
Module cover
9.
Key tool (with key code &
serial number)
NEW! XENA BLUETOOTH APP
Your new XENA Lock is equipped with Bluetooth
connectivity
. Download and install the
FREE
XENA BLE Lock
App
for Android or iOS to adjust alarm volume, sensitivity,
duration, turn ON/OFF and monitor battery life.
(To use without the app, simply insert the battery and use as a
conventional XENA alarmed disc-lock).
SET UP
NOTE! After initial setup, the Bluetooth connection will only activate
once the lock is in place on a disc
.
1.
Download
and install the
XENA BLE Lock App
.
2.
Insert
battery
into the alarm module. You will hear a confirmation “beep” once battery is correctly inserted. Replace
the battery door.
3.
Insert
module
into the lock and replace base plate .
4.
Open the XENA App
and follow the instructions. Name your device and set a password, then adjust alarm settings
and check your battery status. To reset, just remove the battery and re-start the process.
5.
IMPORTANT! After initial setup
, the Bluetooth connection will only activate
once the lock is in place on a disc
. If
the app is closed or interrupted after setup, the lock will need to be on a brake disc to reconnect the App.
6.
After successfully pairing to your Smartphone
and the device is set up, there is no need to enter your
password.
7.
Each time you remove the battery
, the password and device will be reset.
8.
If you use another smartphone or tablet
to connect to your lock, you will need to re-enter the password.
9.
Select
the user language in the settings menu.
CHANGING THE BATTERY
(fig. A & fig. B, overleaf)
•
Locate spring-loaded catch inside disc slot (fig.B).
•
Use key tool to slide back catch; release and remove lid.
•
Locate clear plastic tab on module and lift to remove module from lock body.
•
Remove battery door (marked “CR2 BATTERY”).
•
Remove used battery and discard responsibly.*
•
Ensure that
+
and
–
contacts are properly aligned.
•
Insert fresh CR2 battery and battery door.
•
Carefully replace module in lock body and reattach module cover.
•
The key tool comes in handy to depress the spring-loaded catch.
* Lithium batteries are best disposed of as a non-hazardous waste when fully or mostly discharged.
* DO NOT INCINERATE or subject battery cells to temperatures in excess of 212°F.
NOTE
: When the module is removed from the lock body, the alarm will activate. To minimize this, insert module into lock
body and replace lid immediately after inserting battery.
