Thank you for purchasing Xtend Voice Logger. For proper installation and optimum performance,
please follow the steps given below.
1. Insert CD into CD ROM drive and run the setup "XtendALogger.exe".
2. Welcome Wizard appears as first screen, click
Next.
3
.
Read the License Agreement carefully and select
"I accept the agreement".
Now, click
Next
.
4. Default installation directory is "C:\XtendLogger", click
Next
to proceed.
5. The default program shortcut is Xtend Voice Logger 3.0, click
Next.
6. Check the given location and click
Install
to begin the installation process.
(Note: If the Windows Firewall blocked message appears, then click “Allow access” to proceed
with the installation.)
7. Click
Finish
to complete the installation process.
1. Connect Xtend Voice Logger device using the USB cable to the USB slot on the rear side of the
a
computer. Make sure that it is not connected to the USB slot on the front of computer.
2. The LED on the front-side of device turns red and blinking.
3. Windows shall automatically detect and install the hardware for all operating systems. In case,
if the hardware is not successfully installed then manually update the driver through the
Device
Manager
. Go to
Device Manager
, the device will be detected under
Other Devices
as
"Xtend
Voice Logger Digital Trunk"
with a yellow exclamation sign. Right click and select
“Update
driver software”
. Select
“Search automatically for updated driver software”
from the list of
options and click
Next
to continue.
4. After completing the installation process, the device will be detected as
"Xtend Voice Logger
Digital Trunk"
under
WinUSB/Universal Serial Bus Devices
.
5. If selecting the option
“Search automatically for updated driver software”
doesn’t work, then
select the second option
“Browse my computer for driver software”
. Browse and select the
Voice Logger installed folder “XtendLogger”, click
Next
to continue.
6.
The
software
for
Xtend
Voice
Logger
is
installed,
click
Finish.
Message
appears
as
“Your
new
hardware
is
installed
and
ready
to
use”.
7.
Connect
the
incoming
line
from
the
ISDN
PRI
to
the
“LINE
IN”
and
the
outgoing
“LINE
OUT”
to
the
EPABX
system.
The
LED
turns
green
and
blinking.
Software Setup
Hardware Setup
Installation Instructions
Xtend Voice Logger
Important:
On successful installation, Xtend Web Server icon is enabled on the notification
area of the taskbar.
ISDN PRI
a
Front USB Connectors may not provide the performance necessary to support such transfers due to non-standard wiring. It is
recommended that only rear USB slots be used to connect to Xtend Voice Logger ISDN PRI.
