150PSI 250LPM
DUAL AIR COMPRESSOR
OWNERS MANUAL
THERMAL CUT-OFF AND CIRCUIT BREAKER PROTECTION
This XTM Dual Air Compressor is equipped with an automatic thermal cut-off protection. If the unit reaches an unsafe
operating temperature, a protection circuit will activate cutting off all power of the unit to prevent damage. Immediately
disconnect the unit from the power source and allow it to cool if the protection circuit activates. The unit should take approximately
15 minutes to cool depending on ambient conditions. The unit protection circuit will automatically reset when the temperature
returns to a safe operating level. Always allow your air compressor to cool before reuse. The auto reset circuit breaker is
built-in to protect an electrical circuit from damage caused by overload or short circuit.
TIMER CUT OFF PROTECTION
This XTM Dual Air Compressor is equipped with an automatic timer cut-off protection. After 15 minutes of continuous
operation, the air compressor will cut off to avoid damage.
MAINTENANCE
+ All moving parts within the air compressor have been permanently Iubricated during manufacture. It is
NOT necessary to lubricate this air compressor.
+ Before and after each use, carefully inspect the compressor unit and hoses for signs of damage.
+ Check the air filter regularly, at least every six months. Simply remove the cover and clean the air filter.
To clean the filter gently wash in mild soapy water and rinse well. Replace if worn.
SPECIFICATIONS
:
Voltage: 12 Volt DC
Maximum Pressure: 150 PSI
Maximum Air Flow: 250 Litres Per Minute
Inline Fuse: 100A
Maximum Voltage: 13.8 Volt
Maximum Amp Draw: 90 Amp
Bset Operating Temperature: -15ºC To 35ºC
Electrical Current Protection: Circuit Breaker
Thermal Cut-off Protection: Automatic Thermal Cut-off at I05ºC
Automatic Timer Cut-off After 15 Minutes Continuous Operation
Cylinder Diameter: 2 X 60mm
Power Cord: 2 Metres Heavy Duty Cable With Durable Battery Clamps
Rubber Air Hose: 10 Metres with In-line Pressure Gauge,
Pressure Release Button and Quick Connect Fitting
Valve Connectors: 1 X Screw-on Brass Inflator and 1 X Thumb Lock Adaptor
Pressure Gauge: 0-150 PSI / 0-1, 034 kPa Multi Readings with Plastic Protective Cover
Solid Base Plate: Metal Sand Tray With Rubber Anti - Vibration Feet
Air Filter: Built-ln Cleanable Sponge Filter
Accessories: 3 X Nozzle Adaptors for Camping and Sporting Equipment
Storage: Handy Carry Bag
PLU: 645860 CODE: WM102-15C
Manufactured & packaged for
SRGS PTY LTD
ABN 23 113 230 050
6 Coulthards Avenue
Strathpine QLD 4500, Australia
MADE IN CHINA
TYRE GAUGE PRESSURE READINGS DURING OPERATION
WILL NOT BE ACCURATE. TURN OFF THE AIR COMPRES-
SOR TO OBTAIN AN ACCURATE READING.