1
xxter enOcean manual
xxter b.v.
Elandsgracht 73 I
1016 TR Amsterdam
The Netherlands
Tel. +31 20 6242 865
www.xxter.com
info@xxter.com
This manual is a general instruction for connecting the antenna and configuring xxter with
enOcean. If required enOcean can also be combined with a KNX installation.
To make use of enOcean, please note the following prerequisites:
1) An xxter module type HC01C or newer
2) An xxter enOcean ANE01 antenna
3) The latest configuration tool (version 1.8.3 or newer)
4) The latest firmware (version 1.8.3 or newer)
Connecting the antenna
The enOcean ANE01 antenna has a serial connector and a power split cable, which both
need to be connected. Please follow the following instructions:
1) Make sure the xxter is disconnected from the power.
2) Attach the serial connector of the ANE01 to the serial (RS232) port of your xxter.
3) Attach the power split cable to the xxter unit.
4) Attach the power adapter of the xxter unit to the split cable.
Now the power adaptor can be reconnected to the power socket and the xxter unit as well as
the enOcean antenna will have power.
