Your Xyron Pro1250 is designed to permanently apply an adhesive or clear film to the
front and/or back of any substrate that is run through the machine. The lamination film
and adhesive are not designed to be removed without substantial damage to the laminated
substrate or mounting surface. This process is NOT recommended for any precious or single
source documents. Always test before use – may not be compatible with some surfaces.
The system is designed to be used with one of the following replacement cartridges:
DL1201-150
Two-Sided Lamination – General Use – 150'
SL1201-150
Single-Sided Lamination – General Use – 150'
LAT1201-100 One Side Laminate / One Side Adhesive Application – High Tack – 100'
LAT1206-100 One Side Laminate / One Side Adhesive Application – Repositionable – 100'
AT1201-100
Adhesive Application – High Tack – 100'
AT1202-100
Adhesive Application – Low Tack – 100'
AT1205-100
Adhesive Application – Acid Free – 100'
AT1206-100
Adhesive Application – Repositionable – 100'
Consult your authorized Xyron dealer for information on other supplies.
Please follow the attached directions carefully.
Adhesive Application &
Laminating System
U
S
E
R
’
S
G
U
I
D
E
Adhesive Application and Laminating System
Pro 1250
®
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
