SERVICE TIPS
BRAVO 21 ASSEMBLY
BBC version
Updated: 08/2009
UNPACKING:
Carefully remove the machine from its packaging and check that
you have the following items:
Upper Handle complete
(2) Lower Handle tubes
Mower Bag and Mulch Plug (installed on the mower)
Tool kit
Honda engine Owner’s Manual
Bravo 21 Operator’s Manual.
NOTICE:
If you are missing any of these items or if you are unsure
of how to properly assemble this mower please contact:
service@ybravo.com
by e-mail or by phone: 1.
888.ybravo.1
(1.888.927.2861)
Tools needed for assembly:
10mm wrench
13mm wrench
Philips screwdriver
13mm
10mm
STEP 1
Install the red handle tubes to the mower with the M8 carriage
screws. Do not tighten the nuts. There are three holes for the
upper clamp to enable height adjustment. A good starting point
is the middle hole for a medium height setting.
STEP 2
Slide the upper handle assembly into the two lower tubes.
Insert the two carriage screws and use one square washer on
each side of the handle tube.
I
nstall the nuts finger
tight. Tighten com
-
pletely in step 3.
DIFFICULTY LEVEL - 3
1
2
3
4
5
Novice
Journeyman
15 to 25 Min
Before working -
always
follow all
instructions and warnings described in
the Operator’s Manuals for this mower.
Install the right side front
screw and insert the
mulch plug to hold the
screw during installation.
STEP 3
To simplify the alignment of the handle, install the grass catcher.
Tighten the screws in the following order:
1 - Tighten the two screws on the right side tube clamps
2 - Align the left tube with the catcher (same as the right side)
and tighten the lower clamps.
3 - Tighten the upper screws that attaches the handle assembly
to the tubes.
1
2
3
