background image

15-channel AURORA OVO remote control with display 

and timer, white (AURORA OVO_15RT)

1. Control:

can control single motor, or a group

of up to 20 motors on each channel

2. Range:

200 meters outdoor,

35 meters indoor

3. Battery:

1 x CR2430

4. Power supply:

3 V

5. Dimensions:

136 x 48 x 13 mm

6. Transmitting power:

10 mW

7. Operating temperature:

from 0°C to 50°C

8. Protection degree:

IP 30

Radio receiver range is a variable value and can differ from declared values depending on conditions in which device 

operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters 

etc.

1

2. Detailed description

15-channel transmitter 

with timer

(front)

5-channel transmitter 

with timer

(front)

5 -channel or 15-channel transmitter 

with timer

(back)

1. General information

In order to fully explore available functions of AURORA OVO series please take a moment and read this manual before using the device.

AURORA OVO transmitters are compatible with all YOODA brand devices.

AURORA OVO_5RT   |   AURORA OVO_15RT

www.sukcesgroup.pl

TIME CHANGE

button

Battery

UP button

STOP button

DOWN button

C button

CHANNEL - button

P2 

programming button 

WORK MODE 

button

LCD display

P2

M

P2

Summary of Contents for AURORA OVO 5RT

Page 1: ...es Possible sources of changes in range are building construction interference caused by other radio transmitters etc 1 2 Detailed description 15 channel transmitter with timer front 5 channel transmitter with timer front 5 channel or 15 channel transmitter with timer back 1 General information In order to fully explore available functions of AURORA OVO series please take a moment and read this ma...

Page 2: ...n for longer than 3 seconds causes the transmitter s working modes to change continuously 4 Changing work mode 1 Time can be set only when device is in manual working mode 2 Longer than 60 seconds pause between series of button clicks during programming will cause device to switch off from programming mode without saving any changes 3 To exit the time change mode without saving changes press the S...

Page 3: ...mode Press WORK MODE button Using UP or DOWN buttons to set the opening hour Use the UP or DOWN buttons to set the minutes Using UP or DOWN buttons set appropriate time Pressing the CHANNEL button selects the channel number or the group of channels Use the WORK MODE button to set the next time Press and hold TIME CHANGE button for about 3 seconds to confirm the changes The setting of the automatic ...

Page 4: ...er to R type motors 4 Turn on power supply or press microswitch for 2 sec when power is on Motor will make a sound Roller shutter will make an up down move Motor will make a sound Press P2 programming button or Roller shutter will make an up down move and the motor will make a few short sounds Motor will make a sound Press P2 programming button Press UP button Use the WORK MODE button to set the a...

Reviews: