background image

5-channel MAGNETIC Deluxe YSH remote control with display 

and timer (MAGNETIC Deluxe_5RT YSH)

1. Control:

can control single motor, or a group

of up to 20 motors on each channel

2. Range:

200 meters outdoor,

35 meters indoor

3. Battery:

CR2450

4.Power supply:

3 V

5. Dimensions:

130 x 45 x 10 mm

6. Transmitting power:

10 mW

7. Operating temperature:

from 0°C to 50°C

8. Protection degree:

IP 30

Radio receiver range is a variable value and can differ from declared values depending on conditions in which device 

operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters 

etc.

1

2. Detailed description

UP button

LCD display

STOP button

DOWN button

C (P1 +) button

CHANNEL - (P1 -) button

days of week

minutes

UP

DOWN

low battery 

message

time change 

button

P2

programming button

work mode

button

CR2450

5-channel transmitter with timer

(front)

5-channel transmitter with timer

 (back)

In order to fully explore available functions of MAGNETIC DELUXE YSH series please take a moment and read this manual before using the device.

MAGNETIC DELUXE YSH transmitters are compatible with all YOODA SMART HOME brand devices.

MAGNETIC Deluxe YSH transmitters are dedicated to two-way communication.

MAGNETIC_Deluxe_5RT YSH

1. General information

selected channel

work mode

hour

Summary of Contents for MAGNETIC DELUXE YSH Series

Page 1: ...lding construction interference caused by other radio transmitters etc 1 2 Detailed description UP button LCD display STOP button DOWN button CHANNEL P1 button CHANNEL P1 button days of week minutes UP DOWN low battery message time change button P2 programming button work mode button CR2450 5 channel transmitter with timer front 5 channel transmitter with timer back In order to fully explore avail...

Page 2: ... of button clicks during programming will cause device to switch off from programming mode without saving any changes 1 Each channel can be activated or deactivated in the automatic mode If the channel is inactive the transmitter will not control the receiver in this mode 2 The channel is inactive if number of this channel is flashing 3 Activating channels in automatic mode 4 Changing work mode 5 ...

Page 3: ...low 1 The transmitter can operate in one of two modes a two way b one way 2 The transmitter factory operates in two way mode 6 Setting automatic time of closing and opening 7 Function buttons lock 8 Selection of the transmitter s operating mode Press WORK MODE button to set the automatic working mode Remove the battery from the transmitter Press programming button P2 Press and hold TIME CHANGE but...

Page 4: ... all existing transmitters from memory 4 Choosing 0 group channel means remote controls all programmed devices on all channels at the same time No programming functions can be performed on group channel All devices programmed to any other channel can be controlled on group channel without additional programming 4 Programming first transmitter to EV S type motors Turn on power supply or press progr...

Reviews: