background image

Installation Manual for Motion Sensor Kit

Model

SOR-NEZ

NOTE

The applicable indoor unit may be different depending on the product series. 

Refer to the product catalog for applicable indoor unit models.

IMPORTANT NOTICE:

●  Johnson Controls, Inc. pursues a policy of continuous improvement in design and performance of 

products. We reserve the right to vary specifications without notice.

●  No part of this manual may be reproduced without Johnson Controls’ written permission.
●  Keep this manual for future reference.
●  Johnson Controls cannot anticipate every possible circumstance that might involve a potential hazard.
●  This kit is designed for a combination of Johnson Controls air conditioners. Do not use this kit by itself or in 

combination with other companies’ air conditioners.

●  Perform a test run after installation to check for abnormalities.
●  Signal words are used to identify levels of hazard seriousness. Definitions for identifying hazard levels are 

provided below with their respective signal words.

 

 : 

Indicates a hazardous situation that, if not avoided,

 

 

  could result in death or serious injury.

 

 : 

Indicates a hazardous situation that, if not avoided,

 

 

  could result in minor or moderate injury. 

 

 : 

Indicates information considered important, but not hazard-related

 

 

  (e.g. messages relating to property damage). 

 

NOTE

 : 

Indicates useful information for operation and/or maintenance.

●  It is assumed that this motion sensor kit will be installed and serviced by English speaking people. If this is 

not the case, the customer should add safety, caution and operating signs in the native language.

●  If you have any questions, contact your distributor or contractor.
●  This manual gives a common description and information for this motion sensor kit, as well as for other 

models, which you may operate.

●  This manual should be considered as a permanent part of the air conditioning equipment and should 

remain with the air conditioning equipment. Forward this information to the building owner and request that 

they maintain all the equipment manuals.

Read following sections carefully before installing this product.

Read the Installation and Maintenance Manual for the indoor unit as well.

1

Summary of Contents for SOR-NEZ






Reviews: