High Performance Combo Router BE5
Quick Start Guide Update
Setting up YOYORouter BE5 in Ethernet WAN Mode with Failover
Configure YOYORouter BE5 in Ethernet WAN mode and test the connection.
To add failover to 3G Wireless WAN, ensure that your SIM Card is inserted and the Ethernet WAN is
connected then follow these steps:
1. Log in.
2. Select
Advanced
then
Network Setup
.
3. Make sure that
Connection Control
is set to
Auto Reconnect (always-on)
.
4. Against Combo
WAN Status
, click the
Setting
button.
5. Set
Combo WAN Mode
to
Failover
.
6. Enter an IP address in
Remote Host for Keep Alive
that YOYORouter can ping to check the
connectivity. This can be numeric, e.g. 8.8.8.8 or text, e.g. www.google.com.
7. Your Ethernet WAN connection is shown as
primary WAN
. To add the 3G WAN as failover, click the
Add
button against
Secondary WAN
and select
3G
in the drop-down box.
8. Click the
Save
button.
9. The Dial-Up Profile (connection settings) for 3G mobile broadband are now displayed.
• Select
Auto-Detection
for automatic configuration based on your SIM card (recommended).
• Select
Manual
if you need to select alternative or enter special settings. Select your country and the
network operator, or
Others
to enter your own settings.
• If your SIM requires a PIN code, enter it now.
10.Click the
Save
button then click
OK
to reboot YOYORouter.
BE5 Update double sided:Layout 1 15/12/11 18:01 Page 1
