Installation manual
+
YPHIX LED dimmer CC 700 5ZD
Product code: 50208670
®
One or more LED receivers CC 700 5ZD can be controlled with one RF remote and/or a push switch. Program
multiple receivers up to 5 different zones. If applicable, more than one receiver can be linked to a zone. With only
one click all receivers can be switched on/off simultaneously.
Specifications:
• LED receiver 700mA
• Controlled by: RF remote (up to 25 meters) and/or push switch
• Control multiple receivers with one remote control (separately or simultaneously)
• 1- 5 zones
• 2 memory keys
• 100 % dimmable in 255 steps
• Input: 12V or 24V DC
• Output : 4 x 700mA
Option 1. Control LED receiver CC 700 5ZD with an RF remote RF remote (Product code: 50208610)
Option 2. Control LED receiver CC 700 5ZD with a push switch (Product code: 50178530)
Option 3. Control LED receiver CC 700 ZD with a RF remote and push switch
How to install LED Dimmer CC 700 5ZD
Turn off the main switch.
1. Connect 12V or 24V DC LED power supply to V- and V+ INPUT on the receiver.
Please note!
• Never connect the receiver directly to a battery. Always use a DC-DC converter.
• Always connect all output wires of the power supply to the receiver.
• Connect only one power supply to each receiver.
2. Connect LED light
Connect the two conductor wire of a 700mA LED light to output 1 + and -.
Please note:
connect only one LED lamp to each output (max. 4 LED lamps).
3. Connect Push switch
Connect two conductor wire of push switch to the receiver (as shown in the image).
Please Note!
Do not connect the Push switch to 230V or a different kind of power supply.
Connect remote control to receiver
Turn on the main switch.
A. Press and hold the learning key on the receiver for 5 seconds, to erase its memory.
The light will flash twice to confirm.
B. Press 1/4 second (very short click) on the learning key.
C. Press immediately afterwards (also a short click) the or button on the remote to connect the receiver to a
zone. The LED light will flash once to confirm. The receiver is now connected to a zone.
D. Repeat steps B and C to link multiple receivers to the remote control.
Features:
• Multiple receivers can be connected to one zone. All receivers linked to a zone, respond simultaneously.
• One receiver can be linked to multiple zones.
Dimming
E. Press and hold the or button on the remote to change the light intensity. All receivers in a zone will
respond simultaneously.
Switching on/off
F. Press the or button on the remote to switch the light on and off. All receivers in a zone will respond
simultaneously.
G. Press the ON or OFF button on the remote to switch all the connected light at the same time.
Memory
H. On the remote there are 2 memory keys: M1 and M2. After you have set the correct dimm level, you can save it
by holding the memory key for a few seconds. The lights will flash once to confirm.
I. Repeat step H to change memory setting.
Reset
Press and hold the learning key on the receiver for 5 seconds to erase its memory. Repeat steps B-C to reconnect
the receiver tot the remote.
Push switch
LED Power supply
12-24V DC
Learning key
LED Lamp
LED Lamp
LED Lamp
LED Lamp
ON
OFF
M1
M2
1
1-5
2
3
4
5
+
ON
OFF
M1
M2
1
1-5
2
3
4
5
+
+
