Calibre 733
Automatic Movement Operation Manual
Automatic watches can be used only by those who are reasonably active as the automatic
winding relies on a regular movement of the wrist. The watch must be given an initial manual
wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each
day it will continue to function indefinitely and may be taken off the wrist for a maximum period
of 30 hours. If this period is exceeded the movement will stop and another manual wind will be
necessary. It must be remembered that when worn in bed the movement of the wrist is
insufficient to operate the automatic winding.
Time Stand Accuracy
1)
21,600 beats per hours
2)
Accuracy between -30 to +30 seconds per day worn under normal conditions.
Butterfly Strap Adjusting Instruction
Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required
length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until
it clicks into place.
Page 1
Water Resistance Table
Level of
Water
Resistance
Suitable for
Everyday
use
Can
withstand
accidental
splashing
Suitable for
Swimming
Suitable for
Pool Side
diving
Suitable
for
snorkelling
or water
sports
Suitable for
high board
diving or sub-
aqua diving
None
Yes
No
No
No
No
No
3 ATM
(30m/
100ft
Yes
Yes
No
No
No
No
5 ATM
(50m/
150ft)
Yes
Yes
Yes
Yes
No
No
10 ATM
(100m/
300 ft)
Yes
Yes
Yes
Yes
Yes
No
Water resistance is not permanent. In the course of time, the gaskets of the case and
crown may become worn and reduce the water resistance of your watch. We recommend
the periodic checking.
Normal Crown
– always make sure it is pushed fully into case
Screw down Crown
– tighten screw down crown completely to screw lock position.
To maintain water –resistance crystal, crown and case must remain intact
Exposure to Salt Water
If your watch is designed for sports or working in the water and it becomes exposed to salt
water or significant amounts of perspiration, it should be rinsed in fresh water and dried
thoroughly with a soft dry cloth.
Important
Buttons must not be operated while in contact with water
Page 2
Functions
-
Hours
-
Minutes
-
Seconds
-
Date
-
Day of the Week
-
Month
-
12/24 hour hand
-
Water Resistance – Check the back of the watch and refer to the Table.
Important
Do not set the day & date between 06.00 PM and 06.00 AM, as this may
cause damage to the movement.
Instructions for setting Day, Date, Month and Time
1)
To achieve an accurate day setting, by using a pointed device, press button C
until a day prior to the day you required is achieved i.e. if today is the
Wednesday then set it onto the Tuesday.
2)
To achieve an accurate date setting press button A until the date prior to date
you required, i.e. if today is 16
th
then set it onto 15
th
.
3)
Press button B to set the correct month.
4)
Now pull the crown out to first position and turn the crown anti-clockwise until the
correct day and date is achieved. The day and date will now be corrected, now
set the home time making sure the time is set in accordance with AM or PM.
5)
The 12/24 hour hand will indicate AM or PM.
6)
Finally push the crown back to normal position.
Page 3
Page 4
Calibre 733
IN1702
Page 6
