3nStar RPT008, Programmer'S Manual

Programmer

Manual

FF(*)

CR

CAN (*)

[Name] Print and return to standard mode in page mode 

[Format]  

ASCII         FF 

                  Hex            0C

                  Decimal     12 

[Description] Prints the data in the print buffer collectively and returns to standard mode. 

[Details] • The buffer data is deleted after being printed. 

              • The printing area set by 

ESC W

 is reset to the default setting. 

              • The printer does not execute paper cutting. 

              • This command sets the print position to the beginning of the line. 

              • This command is enabled only in page mode. 

[Reference] 

ESC FF, ESC L, ESC S 

[Name] Print and carriage return

[Format]  

ASCII         CR 

                 Hex             0D 

                 Decimal      13 

[Description] When automatic line feed is enabled, this command functions the same as LF;

                     When automatic line feed is disabled, this command is ignored. 

[Details] • Sets the print starting position to the beginning of the line. 

              • The automatic line feed is ignored with a serial interface model. 

              • This command is set according to the DIP switch 1-1 setting with a parallel interface model. 

[Reference] 

LF

[Name] Cancel print data in page mode

[Format]  

ASCII        CAN 

                 Hex            18 

                 Decimal     24 

[Description] In page mode, deletes all the print data in the current printable area. 

[Details]  • This command is enabled only in page mode. 

               • If data that existed in the previously specified printing area also exists in the currently specified printing area, it is deleted. 

[Reference] 

ESC L, ESC W

[Name] Real-time status transmission

[Format]  

 ASCII        DLE       EOT       n 

                 Hex             10           04         n 

                 Decimal      16            4          n 

[Range] 1 

≤ 

n 

≤ 

4 

[Description] Transmits the selected printer status specified by n in real-time, according to the following parameters: 

                      n = 1: Transmit printer status 

                      n = 2: Transmit off-line status 

                      n = 3: Transmit error status 

                      n = 4: Transmit paper roll sensor status

[Details] • The status is transmitted whenever the data sequence of <10>H<04>H< n> (1 

≤ 

n 

≤ 

4) is received. 

                 Example: 

                 In ESC 

∗

 m nL nH d1...dk, d1=<10>H, d2=<04>H, d3=<01>H 

              • This command should not be used within the data sequence of another command that consists of 2 or more bytes. 

                 Example: 

                 If you attempt to transmit ESC 3 n to the printer, but DTR (DSR for the host computer) goes to MARK before n is trans-  

   mitted andthen DLE EOT 3 interrupts before n is received, the code <10>H for DLE EOT 3 is processed as the code for 

   ESC 3 <10>H. 

DLE EOT n (*)