31
Serial & Telnet Commands
Serial and Telnet Commands
COMMAND
DESCRIPTION AND PARAMETERS
SET FACTORY DEFAULT
8
Reset the unit to the factory defaults.
SET SYSTEM REBOOT
8
Reboot the unit.
SET IP MODE STATIC
8
Set the IP address assignment mode to static.
SET IP MODE DHCP
8
Set the IP address assignment mode to DHCP.
SET IP MODE N1
8
Set the IP address assignment mode.
Available values for
N1
:
0 [Static IP Mode]
1 [DHCP Mode]
GET IP MODE
8
Show the current IP address assignment mode.
GET IPADDR
8
Show the unit’s current IP address.
SET STATIC IPADDR N1
8
Set the unit’s static IP address.
N1
= X.X.X.X [X = 0 ~ 255, IP address]
SET STATIC NETMASK N1
8
Set the unit’s static netmask.
N1
= X.X.X.X [X = 0 ~ 255, netmask]
GET STATIC NETMASK
8
Show the unit’s current netmask.
SET STATIC GATEWAY N1
8
Set the unit’s static gateway address.
N1
= X.X.X.X [X = 0 ~ 255, gateway address]
GET STATIC GATEWAY
8
Show the unit’s current gateway address.
SET WEBGUI USERNAME N1
8
Set the WebGUI login username.
N1
= {Name} [16 characters max]
GET WEBGUI USERNAME
8
Show the current WebGUI login username.
SET WEBGUI PASSWORD N1
8
Set the WebGUI login password.
N1
= {Name} [16 characters max]
GET WEBGUI PASSWORD
8
Show the current WebGUI login password.
SET OUT A ROUTE N1
8
Route the specified input to both outputs.
Available values for
N1
:
1 [USB-C input]
2 [DisplayPort input]
3 [HDMI input 1]
4 [HDMI input 2]
5 [HDMI input 3]
6 [HDMI input 4]
7 [HDMI input 5]
8 [VGA input]
GET OUT A ROUTE
8
Show the current input routed to both outputs.
SET OUT AUTO MODE N1
8
Set the auto switching behavior of the unit.
Available values for
N1
:
0 [Off]
1 [Auto switch]
GET OUT AUTO MODE
8
Show the current auto switching mode of the unit.
GET IN N1 TIMING
8
Show the index number of the current resolution detected on the specified input.
Available values for
N1
:
1 [USB-C input]
2 [DisplayPort input]
3 [HDMI input 1]
4 [HDMI input 2]
5 [HDMI input 3]
6 [HDMI input 4]
7 [HDMI input 5]
8 [VGA input]
A
NEU
VIDEO
