B2.36
CPU Auxiliary Control Register, EL1
The CPUACTLR_EL1 characteristics are:
Purpose
Provides
IMPLEMENTATION DEFINED
configuration and control options for the processor. There is
one 64-bit CPU Auxiliary Control Register for each core in the processor.
Usage constraints
This register is accessible as follows:
EL0 EL1
(NS)
EL1
(S)
EL2 EL3
(SCR.NS = 1)
EL3
(SCR.NS = 0)
-
RW
RW RW RW
RW
The CPU Auxiliary Control Register can be written only when the system is idle. Arm
recommends that you write to this register after a powerup reset, before the MMU is enabled,
and before any master interface or ACP traffic begins.
Setting many of these bits can cause significantly lower performance on your code. Therefore, it
is suggested that you do not modify this register unless directed by Arm.
Configurations
CPUACTLR_EL1 is:
• Common to the Secure and Non-secure states.
• Mapped to the AArch32 CPUACTLR register.
B1.42 CPU Auxiliary Control Register
.
Attributes
CPUACTLR_EL1 is a 64-bit register.
31
22
18 17
0
9
10
11
12
13
15
16
19
20
21
28
29
RES
0
DIDIS
RES
0
L1PCTL
L1RADIS
RADIS
NPFSTRM
DSTDIS
STRIDE
63
CDIDIS
30
23
24
STBPFDIS
STBPFRS
27 26 25
DTAH
RES
0
ENDCCASCI
45 44 43
7
RES
0
6 5
DODMBS
L1DEIEN
RES
0
RES
0
DYNSDIS
Figure B2-11 CPUACTLR_EL1 bit assignments
[63:45]
Reserved,
RES0
.
ENDCCASCI, [44]
Enable data cache clean as data cache clean/invalidate. The possible values are:
0
Normal behavior, data cache clean operations are unaffected. This is the reset value.
B2 AArch64 system registers
B2.36 CPU Auxiliary Control Register, EL1
100236_0100_00_en
Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
B2-412
Non-Confidential
Summary of Contents for Cortex-A35
