1.
External power.
2.
Embedded Debugger USB.
3.
Target USB.
Info:
External power is required when 500mA from a USB connector is not enough to power
the board with possible extension boards. A connected USB device in a USB host application
might easily exceed this limit.
3.4.
Xplained Pro Headers and Connectors
3.4.1.
Xplained Pro Standard Extension Header
All Xplained Pro kits have one or more dual row, 20-pin, 100mil extension header. Xplained Pro MCU
boards have male headers, while Xplained Pro extensions have their female counterparts. Note that all
pins are not always connected. All connected pins follow the defined pin-out description in the table
below.
The extension headers can be used to connect a variety of Xplained Pro extensions to Xplained Pro MCU
boards or to access the pins of the target MCU on Xplained Pro MCU boards directly.
Table 3-4. Xplained Pro Standard Extension Header
Pin number
Name
Description
1
ID
Communication line to the ID chip on an extension board
2
GND
Ground
3
ADC(+)
Analog to digital converter, alternatively positive part of differential
ADC
4
ADC(-)
Analog to digital converter, alternatively negative part of differential
ADC
5
GPIO1
General purpose I/O
6
GPIO2
General purpose I/O
7
PWM(+)
Pulse width modulation, alternatively positive part of differential
PWM
8
PWM(-)
Pulse width modulation, alternatively negative part of differential
PWM
9
IRQ/GPIO
Interrupt request line and/or general purpose I/O
10
SPI_SS_B/
GPIO
Slave select for SPI and/or general purpose I/O
11
I
2
C_SDA
Data line for I
2
C interface. Always implemented, bus type.
12
I
2
C_SCL
Clock line for I
2
C interface. Always implemented, bus type.
13
UART_RX
Receiver line of target device UART
14
UART_TX
Transmitter line of target device UART
Atmel SAM D11 Xplained Pro [USER GUIDE]
Atmel-42349B-SAM-D11-Xplained-Pro_User Guide-04/2016
9
