CLI Commands
Dialer interface
328 Avaya G450 CLI Reference
User Level
read-write
Context
interface:Dialer (L2, L2-L3)
Example
To set the redial interval to 20 seconds:
G450-001(if:Dialer 1)# dialer persistent delay 20
Related Commands
,
dialer persistent max-attempts
dialer persistent initial delay
Use the
dialer persistent initial delay
command to set the minimum delay from
boot to persistent dialing. Use the
no
form of the command to return the delay to the default
value.
Note:
Note:
Use this command to prevent the Dialer interface from dialing out after the G450
is reset. This is needed because the primary interface does not become active
immediately after the reset.
Syntax
[no] dialer persistent initial delay
sec
Parameters
User Level
read-write
Context
interface:Dialer (L2, L2-L3)
Parameter
Description
Possible
Values
Default
Value
sec
Initial delay
1-1000
1
Summary of Contents for G450 Manager
