SDM-INT8 8 Channel Interval Timer
3: Beginning of Loop (P87)
loop to make a 10 sec.
1: 1
Delay
delay
2: 20
Loop
Count
4: End (P95)
end of loop
5: Do (P86)
set the output
1: 10
Set
high
Flag 0 (output)
flag
6: Real Time (P77)
time tag the output
1: 11
Hour-Minute,
Seconds
7: Do (P86)
retrieve INT8 data
1: 1
Call
Subroutine
1
8: Do (P86)
initialize flag 2
1: 22
Set low Flag 2
9: End Table 1 (P)
*Table 3 Subroutines
1: Beginning of Subroutine (P85)
1: 1
Subroutine
Number
2: SMD-INT8 (Extended) (P101)
1: 0
Address
Option
2: 0001
Chan8765=HLrise/HLrise/HLrise/HLfall/
3: 0000
Chan4321=HLrise/HLrise/HLrise/HLrise/
4: 0003
Chan8765=none/none/none/TsinceP/
5: 0502
Chan4321=none/C2sincel/none/kHz/
6: 20--
Edges of Chan 1 in events mode
7: 1
Loc: <--- Ignored in "Events" Option
8: 1
Mult
9: 0
Offset
3: End (P95)
7.2.2 Wind Speed Measurements - Execution Interval Averaging
The INT8 is used to make 1 second averages of frequencies from 6 RM Young
Wind Monitors. Frequencies are converted to wind speed in m/s, and place in
Input Locations 1 - 6. Wind directions are then measured, scaled, and placed
in Input Locations 7-12. Programming does not output the data to the
dataloggers' Final Storage.
Note that wind speeds of less than 0.2 m/s, corresponding to 2 Hz, will read 0
if a cycle of the Wind Monitor does not get completed within the 1 second
execution interval.
23
