admin-state
To configure the transport administration state on a DWDM port, use the
admin-state
command in DWDM
configuration mode. To return the administration state from a DWDM port to the default, use the
no
form of
this command.
admin-state
{
in-service
|
out-of-service
}
no admin-state
{
in-service
|
out-of-service
}
Syntax Description
Places the DWDM port in In Service (IS) state, to support all normal operation.
in-service
Places the DWDM port in Out of Service (OOS) state. The laser is turned off
and all traffic flow is stopped. This is the default.
out-of-service
Command Default
Out-of-service is the default transport administration state.
Command Modes
DWDM configuration
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
When you configure
admin-state out-of-service
, the DWDM port is placed in OOS state. The laser is turned
off, traffic flow is stopped, and proactive protection is disabled. However, configuration changes can still be
made on the port.
Task ID
Operations
Task ID
read, write
dwdm
Examples
The following example shows how to turn on the laser and place a DWDM port in In Service (IS) state:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
3
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
admin-state
