S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-113
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
logging server
logging server
To configure a remote syslog server at the specified hostname or IPv4/IPv6 address, use the
logging
server
command. To disable the remote syslog server, use the
no
form of this command.
logging server
host
[
severity-level
] [
facility
facility
|
use-vrf
{
vrf_name
|
management
}]
no logging server
host
[
severity-level
] [
facility
facility
|
use-vrf
{
vrf_name
|
management
}]
Syntax Description
Command Default
The default outgoing facility is
local7
.
The default VRF is
management
.
Command Modes
Global configuration mode
Command History
host
Hostname or IPv4/IPv6 address of the remote syslog server.
severity-level
(Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
0
—emergency: System unusable
•
1
—alert: Immediate action needed
•
2
—critical: Critical condition—default level
•
3
—error: Error condition
•
4
—warning: Warning condition
•
5
—notification: Normal but significant condition
•
6
—informational: Informational message only
•
7
—debugging: Appears during debugging only
facility
facility
(Optional) Specifies the outgoing
facility
. The facility can be one of the
following:
auth
,
authpriv
,
cron
,
daemon
,
ftp
,
kernel
,
local0
,
local1
,
local2
,
local3
,
local4
,
local5
,
local6
,
local7
,
lpr
,
,
news
,
syslog
,
user
,
uucp
The default outgoing facility is
local7
.
vrf
vrf_name
(Optional) Specifies the virtual routing and forwarding (VRF) to be used in
the remote server. The name can be a maximum of 32 alphanumeric
characters.
management
Specifies the management VRF. This is the default VRF.
Release
Modification
5.0(3)U1(1)
This command was introduced.
