S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
-SM-316
Cisco Nexus 3000 Series NX-OS System Management Command Reference
OL-29557-04
Chapter System Management Commands
snmp-server user
snmp-server user
To configure a new user to a Simple Network Management Protocol (SNMP) group, use the
snmp-server user
command. To remove a user from an SNMP group, use the
no
form of this command.
snmp-server user
username
[
groupname
] [
auth
{
md5
|
sha
}
auth-password
[{
engineID
engine-ID
|
localizedkey
|
priv
{
priv-password
|
aes-128
}}]]
no snmp-server user
Syntax Description
Command Default
None
Command Modes
Global configuration mode
Command History
Examples
This example shows how to configure an SNMP user named authuser with authentication and privacy
parameters:
switch#
configure terminal
username
Name of the user on the host that connects to the agent. The name can be a
maximum of 32 alphanumeric characters.
groupname
(Optional) Name of the group to which the user is associated. The name can
be a maximum of 32 alphanumeric characters.
auth
(Optional) Specifies that an authentication level setting will be initiated for
the session.
md5
(Optional) Specifies that the HMAC-MD5-96 authentication level be used
for the session.
sha
(Optional) Specifies that the HMAC-SHA-96 authentication level be used
for the session.
auth-password
(Optional) Authentication password for the user that enables the agent to
receive packets from the host. The password can be a maximum of 130
characters.
engineID
engine-ID
(Optional) Specifies the SNMP engine ID.
localizedkey
(Optional) Specifies whether the passwords are in localized key format.
priv
(Optional) Initiates a privacy authentication level setting session.
priv-password
(Optional) Privacy password for the user that enables the host to encrypt the
content of the message that it sends to the agent. The password can be a
maximum of 130 characters.
aes-128
(Optional) Specifies that a 128-bit AES algorithm for privacy be used for
the session.
Release
Modification
5.0(3)U1(1)
This command was introduced.