Unified Services Router
CLI Reference Guide
57
4
Username
Enter the username required to log in to
the ISP.
String
5
Passw ord
Enter the passw ord required to login to
the ISP
String
6
Dial_number
Enter the number to dial to the ISP
String
7
AuthMethod
Select one of None, PAP or CHAP
Authentication Protocols to connect to
the ISP
THREEG Authentication Types.
8
Apn
Enter the APN(Access Point Name)
provided by the ISP
String
9
Reconnect_mode
Select Alw ays On: The connection is
alw ays on OR On Demand :The
connection w ill close after time specified
in Idle_time field
ISP Connectivity Types.
10
Idle_time
The connection is automatically ended if
it is idle for a specified number of minutes
idle timeout value type.
11
Get_dns_from_isp
Enter Yes to get dns dynamically from
ISP if you have not been assigned any
static IP address. The ISP w ill
automatically assign an DNS address to
the router using THREEG netw ork
protocol. Otherw ise Enter No and give
valid static dns addresses
Boolean choice
12
Primary_dns
Valid primary DNS Server IP Address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
13
Secondary_dns
Valid secondary DNS Server IP Address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
8.33 net wan mode configure
S.No
Com mand Nam e
Description
Type and Description
1
save
Save w an mode configuration changes.
2
cancel
Roll back ipv4 w an configuration
changes.
3
exit
Save w an mode configuration changes
and current mode.
4
w an_mode_type
Select among the options:
SINGLE_WAN, LOAD_BALANCING,
AUTO_ROLLOVER
Types of WAN modes
5
loadbalancing
If Mode Type selected is
LOAD_BALANCING, this field gives you
options to configure LOAD_BALANCING
credentials
6
loadbalancing algo
Enter the type of LoadBalancing Algo
Types of Loadbalancing algorithms
7
loadbalancing failover_method Select the Fail Over detection method
8
loadbalancing spillover
Spill Over Configuration Parameters
9
loadbalancing spillover
load_tolerance
Percentage of max bandw idth after which
the router sw itches to secondary WAN
Unsigned integer
10
loadbalancing spillover
max_bandw idth
Sets the maximum bandw idth tolerable
by the Primary WAN.If the bandw idth
goes below the load tolerance value of
configured Max Bandw idth, the router
sw itches to secondary WAN.
Unsigned integer
11
loadbalancing failover_method
type
Select the Fail Over detection method
Types of Faillover Detection
