User Manual
UMN:CLI
V8102
121
Command
Mode
Description
module ddm
{
enable
|
disa-
ble
}
all
Global
Specifies whether to collect DDM information
from all SFP modules.
module ddm
{
enable
|
disa-
ble
}
Interface
[GE/XE/GPON]
Specifies whether to collect DDM information
from SFP modules in the specified interface.
This
module ddm
function is enabled by default.
Thus, if you don’t want to get DDM in-
formation, configure this setting as disable.
To display the status of DDM function, use the following command.
Command
Mode
Description
show module ddm
Enable
Global
Displays the status of DDM function.
You can monitor the DDM information of the SFP ports when using the
show interface
module-info
command.
6.1.5.1
SFP Module Operation
The system module will operate depending on monitoring type of temperature, RX/TX
power, voltage or Txbias. To set the threshold of module, use the following command.
Command
Mode
Description
threshold module
{
rxpower
|
txpower
}
{
alarm
|
warning
}
START-VALUE STOP-VALUE
{
sfp
|
system
}
Interface
[GE/XE/GPON]
Sets the Diagnostics threshold of SFP module
by RX/TX power and monitors the module.
The range of RX/TX power: -40
∼
8.1647 dBm
threshold
module
temper
{
alarm
|
warning
}
START-
VALUE
STOP-VALUE
{
sfp
|
system
}
Sets the Diagnostics threshold of SFP module
depending on temperature and monitors the
module
The range of temperature: -128
∼
127.99
℃
threshold
module
txbias
{
alarm
|
warning
}
START-
VALUE
STOP-VALUE
{
sfp
|
system
}
Sets the Diagnostics threshold of SFP module
depending on txbias and monitors the module.
The range of txbias: 0
∼
131 mA
threshold
module
voltage
{
alarm
|
warning
}
START-
VALUE
STOP-VALUE
{
sfp
|
system
}
Sets the Diagnostics threshold of SFP module
depending on voltage and monitors the module.
The range of voltage: 0
∼
6.5535 V
i
i
