UMN:CLI
User Manual
V8102
868
13.8.2
Basic Service Type
To specify the basic service type, use the following command.
Command
Mode
Description
service-type
{
unstructured
|
octet-aligned-unstructured
|
structured
}
TDM-PW-
Profile
Specifies the basic service type, either a transparent bit
pipe or an encapsulation that recognizes the underlying
structure of the payload.
unstructured: Basic unstructured (also known as struc-
ture agnostic)
octet-aligned-unstructured: Octet-aligned unstructured,
structure agnostic. Applicable only to DS1, a mode in
which each frame of 193 bits is encapsulated in 25
bytes with 7 padding bits
structured: Structured (structure-locked)
13.8.3
Signalling
To configure the signalling, use the following command.
Command
Mode
Description
signalling
{
no-signalling
|
cas-
carry-packet
|
cas-carry-
channel
}
TDM-PW-
Profile
Specifies the signalling attribute.
no-signalling: No signalling visible at this layer
cas-carry-packet: CAS, to be carried in the same pack-
et stream as the payload
cas-carry-channel: CAS, to be carried in a separate
signalling channel
13.8.4
Payload Size
To specify the payload size per packet, use the following command.
Command
Mode
Description
payload-size
{
192
|
200
|
256
|
1024
}
TDM-PW-
Profile
Defines the number of payload bytes per packet. Valid
only if service type = unstructured or unstructured oc-
tet-aligned. Valid choices depend on the TDM service
as follows.
192: DS1
200: DS1, required only if unstructured octet-aligned
service is supported
256: E1
1024: DS3 / E3
no payload-size
Deletes the configured payload size.
