108 Alphabetical list of commands
set network-parameters
Description
Sets parameters for controller module network ports.
You can manually set static IP values for each controller, or you can specify that IP values should be
set automatically for both controllers through communication with a Dynamic Host Configuration
Protocol (DHCP) server.
Each controller has the following factory-default IP settings:
•
DHCP: disabled
•
Controller A IP address: 10.0.0.2
•
Controller B IP address: 10.0.0.3
•
IP subnet mask: 255.255.255.0
•
Gateway IP address: 10.0.0.1
When DHCP is enabled, the following initial values are set and remain set until the system is able to
contact a DHCP server for new addresses.
•
Controller IP addresses: 169.254.x.x (where the value of
x.x
is the lowest 16 bits of the controller
serial number)
•
IP subnet mask: 255.255.0.0
•
Gateway IP address: 0.0.0.0
169.254.
x.x
addresses (including gateway 169.254.0.1) are on a private subnet that is reserved for
unconfigured systems and the addresses are not routable. This prevents the DHCP server from
reassigning the addresses and possibly causing a conflict where two controllers have the same IP
address. As soon as possible, change these IP values to proper values for your network.
To switch a controller from DHCP addressing to static addressing, you must set the IP address,
netmask, and gateway values.
NOTE:
The following IP addresses are reserved for internal use by the storage system:
192.168.200.253, 192.168.200.254, 172.22.255.253, 172.22.255.254, and 127.x.x.x.
Min. role
manage
Syntax
set network-parameters
[controller a|b]
[dhcp]
[gateway
gateway
]
[ip
address
]
[ipv 4|6]
[netmask
netmask
]
[ping-broadcast enabled|disabled|on|off]
Parameters
controller a|b
Optional. For IP-related parameters, this specifies whether to apply settings to controller A or B. If this
parameter is omitted, settings are applied to the controller being accessed. This parameter does not
apply to Ethernet switch-related parameters, whose settings are always applied to the controller
being accessed.
dhcp
Optional. Specifies to use DHCP to set both controllers’ IP values.
gateway
gateway
Optional. A gateway IP address for the port.
ip
address
Optional. An IP address for the port.
Summary of Contents for AssuredSAN 6004
Page 11: ...Document conventions and symbols 11 TIP Provides helpful hints and shortcuts...
Page 114: ...114 Alphabetical list of commands See also set cli parameters show protocols...
Page 139: ...show controller statistics 139 See also reset all statistics reset controller statistics...
Page 162: ...162 Alphabetical list of commands See also show power supplies...
