151
31.1
Mixed Configuration
Consider an example of ONT configuration, which simultaneously uses both management domains.
Port numbers and the internal structure are shown in Fig. 31.2.
Step 1.
Create a VLAN for services on the switch. VLAN configuration is described in detail in Chapter
LTP-8X(switch)(config)# vlan 20
LTP-8X(switch)(config-vlan)# tagged front-port 0
LTP-8X(switch)(config-vlan)# tagged pon-port 0 – 1
LTP-8X(switch)(config-vlan)# exit
LTP-8X(switch)(config)# vlan 30
LTP-8X(switch)(config-vlan)# tagged front-port 0
LTP-8X(switch)(config-vlan)# tagged pon-port 0 – 1
Step 2.
Specify "3" as a service model value corresponding to the "VLAN for Service" model by using
the
gpon olt model
command:
LTP-8X# configure terminal
LTP-8X(config)# gpon olt model 3
Step 3.
Define
cross-connect
profiles for services.
LTP-8X(config)# profile cross-connect RG-service
LTP-8X(config-cross-connect)("RG-service")# exit
LTP-8X(config)# profile cross-connect OMCI-service
Step 4.
Define a DBA profile. DBA parameters are not important for the purposes of this chapter.
Thus, we will not configure these parameters, just use the default values. We will also assign one profile
to both services that means that upstream services will operate with one T-CONT. DBA configuration is
described in detail in Chapter 29.
LTP-8X(config)# profile dba basic
LTP-8X(config-dba)("basic")# exit
Step 5.
Create a "ports" profile.
LTP-8X(config)# profile ports 2RG-2OMCI
LTP-8X(config-ports)("2RG-2OMCI")# exit
Step 6.
Configure a routed service. Use one VLAN 20 on both the OLT and ONT sides. Specify a routed
service by using the no bridge command. Configure a cross-connect profile for the routed service.
LTP-8X(config)# profile cross-connect RG-service
LTP-8X(config-cross-connect)("RG-service")# no bridge
LTP-8X(config-cross-connect)("RG-service")# type general
LTP-8X(config-cross-connect)("RG-service")# tag-mode single-tagged
LTP-8X(config-cross-connect)("RG-service")# outer-vid 20
LTP-8X(config-cross-connect)("RG-service")# outer-cos unused
LTP-8X(config-cross-connect)("RG-service")# user vid untagged
LTP-8X(config-cross-connect)("RG-service")# mac-table-limit unlimited
LTP-8X(config-cross-connect)("RG-service")# priority 0
Summary of Contents for LTP-4X
