C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.17 ALIAS parameter
3.2.17.1 ALIAS.<type>
Parameter syntax
This parameter defines an alias name for each command
c_type/c_index
and
c_subindex
and use it further with the defined alias name instead of its default
name.
<type_index_subindex>
It specifies the command
c_type/c_index
and
c_subindex
to be otherwise called.
<alias_name>
It specifies the alias name which will correspond to the last
specified command
c_type/c_index
and
c_subindex
.
How to set/get Alias configuration:
Set configuration
$PFAL,Cnf.Set,ALIAS.SYS=System
$PFAL,Cnf.Set,ALIAS.CNF=Config
$PFAL,CNF.Set,ALIAS.SYS.TIMER0=_1SEC
$PFAL,CNF.Set,ALIAS.SYS.TIMER1=_20SEC
$PFAL,CNF.Set,ALIAS.SYS.TIMER5=_KEYFOB
$PFAL,CNF.Set,ALIAS.SYS.TRIGGER0=TRIGGER_POWERSAVE
Get configuration
$PFAL,Cnf.Get,ALIAS.SYS
$PFAL,Cnf.Get,ALIAS.CNF
Notes
•
The
“$PFAL,Cnf.Set,ALIAS.SYS.TIMER0=_1SEC”
input message sent to the
MAMBOII does not mean that the
“SYS.TIMER0”
is equal to
“_1SEC”
. It means
that the alias name for
“0”
is
“_1SEC”
. Below an example, which shows how to
declare alias names if already defined. For
more information about default
setting see chapter
on page
$PFAL,CNF.Set,AL1=SYS.TIMER.e2&GSM.sOpInvalid:SYS.TIMER
_1SEC
.start=cyclic,60000
3.2.18 DBG parameter
3.2.18.1 DBG.EN
Parameter syntax
This parameter enables a special debug mode that displays the data being sent to
the MAMBOII device and responses received. The integrated debugger can help
you to track down the initialization/execution of the firmware, to monitor the
specified values and settings and runtime errors, etc. This parameter is managed by
the system rather than by the user. It can be used only to read out the validity of
the system debugging.
<
enable
>
It specifies the value of the system-debugging mode. It can be:
Value
Meaning
0
Disables debugging mode.
1
Enables debugging mode.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 172 of 271