6
13. Print the available space and data name in the memory
Syntax
~Xn
Parameter
n = 1, print label format names and available space in memory.
n = 2, print graphic names and available space in memory.
n = 3, print Bit-Mapped font names and available space in memory.
n = 4, print the name of the label formats, graphics, fonts, and available space in memory.
n = 5, print Asia font names and available space in memory.
n = 6, display the total printed length on the LCD
Description Print the available space in the memory card
（
unit:bytes
）
14. Reset printer
Syntax
~Z
Parameter
None
Description Reset the printer. LED will flash once.
Setup commands
1. Printing mode
Syntax
^Ax
Parameter
X = D or T
Description x = D , Direct thermal mode
x = T , Thermal transfer mode
Direct Thermal mode
Thermal Transfer mode, start the Ribbon Out function
。
2. Set the backward length
Syntax
^Bx
Parameter
x = backward length (mm)
Description Set the backward length of the paper.
3. Stop position setting
Syntax
^Mx
Parameter
x = forward length (mm)
Description Set the forward length of the paper.
4. Stop position setting
Syntax
^Ex
Parameter
X = 0 ~ 40 (unit : mm)
Description Feed paper to desired stop position.
When Turn on peel-off function
，
Setting x =10 is better
。
Use the label with Gap
，
Setting x =12
；
With cutter, it depends.
5. Number of copies per label
Syntax
^Cx
Parameter
x = 0 ~ 32767
Description Number of copies of the same label (refer toP23)
