189
lldp hold-multiplier
Syntax
lldp hold-multiplier
value
undo lldp hold-multiplier
View
System view
Default level
2: System level
Parameters
value
: Sets the TTL multiplier, ranging from 2 to 10.
Description
Use the
lldp hold-multiplier
command to set the TTL multiplier.
Use the
undo lldp hold-multiplier command
to restore the default.
By default, the TTL multiplier is 4.
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL information of a device is determined by the following expression:
TTL multiplier × LLDPDU transmit interval
The TTL can be up to 65535 seconds. Longer TTLs will be rounded off to 65535 seconds.
Related commands:
lldp timer tx-interval
.
Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6
lldp management-address-format string
Syntax
lldp management-address-format string
undo lldp management-address-format
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the
lldp management-address-format string
command to encapsulate the management address in
the form of strings in TLVs.
