10-6
Remote Operations
Model 2701 User’s Manual
Miscellaneous system commands
Also included in Table 10-1 are system commands to control remote/local operation, re-
boot the 2701, and acquire the serial number and revision of the main PC board. System
commands not covered in this section are provided in Section 14. All SYSTem commands
are listed in Table 15-7.
Table 10-1
SYSTem commands
Command
Description
SYSTem
:LOCal
Take 2701 out of remote and restore operation
of front panel controls.
:REMote
Place 2701 in remote.
:RWLock
Lockout front panel controls.
:RESet
Immediately re-boots the 2701.
:BOARd
PC board:
:SNUMber?
Acquire serial number of PC board.
:REVision?
Acquire revision level of PC board.
:BATTery
Battery:
:PRESent?
Is a battery installed?; 0 = no, 1 = yes.
:STATus?
Returns “OK”, “MEMORY LOST,” or “CHARGING
FAILURE”. Memory is lost when the battery is not installed
and upon a reset after a firmware upgrade. A charging failure
occurs when it is time for a new battery.
:PASSword
Password:
:ENABle <b>
Enable or disable the use of a password.
:ENABle?
Query the state of password usage.
:CDISable <password>
Disables protected commands.
1, 2
[:CENable] <password>
Enables protected commands.
1
:STATe <b>
Returns “0” if password protected commands are disabled.
Returns “1” if they are enabled.
:NEW <password>
Set new password.
1
1. There is no query form for this command.
2. The following commands and queries are NOT disabled by :PASSword:CDISable. Commands and queries not listed are not
affected by :PASS:CDIS.
*ESE?
*OPT?
SYST:BOAR:SNUM?
SYST:PASS:CDIS
*ESR?
*SRE
SYST:BOAR:REV? SYST:PASS:CEN
*IDN?
*SRE?
SYST:ERR?
SYST:PASS:CEN:STAT?
*OPC
*STB?
SYST:LFR? SYST:REM
*OPC?
STAT:QUE:NEXT?
SYST:LOC
SYST:VER
2701-900-01.book Page 6 Wednesday, August 3, 2011 9:43 AM
Summary of Contents for 2701
