STEP 2:
Connect the motors with the Arduino. (Refer the getting started manual)
STEP 3:
Use the connecting wires to connect the moisture sensor with Arduino. Make connection between the Sensor and
Connection Board and then between Connection Board and Arduino.
The Connection board has 6 pins, Two pins (+, -) on one side, connect them to the sensor, Four pins (AO, DO, GND,
Vcc) on the other side, connect them to Arduino.
Connection Board Pins
Arduino
DO
Pin 3
Vcc
5V
GND
GND
STEP 4:
Connect the CODI with the computer and startup ArduBlock via Arduino. (Refer Getting started manual for setup and
installation).
STEP 5:
Make the Code as follows:
1.
Select a do loop from control panel
Summary of Contents for CODIBOT
Page 1: ......
