Software Options
You must use the USRP RIO IDL when programming the USRP-2974.
Note
The NI-USRP API is not supported when programming the USRP-2974.
•
Description:
–
Allows you to interface with the FPGA of your USRP-2974 for advanced
programming and digital signal processing (DSP).
–
Uses the USRP RIO Sample Projects, which allow you to take common
measurements with your device. USRP RIO Sample Projects are included in the
installation.
•
Use Case: Use with LabVIEW Communications System Design Suite to customize the
behavior of the device FPGA to create application-specific instrument designs.
•
Location:
–
(LabVIEW Communications System Design Suite 2.1 to Current) On the
Diagram
tab, select
Hardware Interfaces
»
Wireless Design and Test
»
USRP RIO
from the
palette.
–
(LabVIEW Communications System Design Suite 2.0) On the
Diagram
tab, select
Hardware Interfaces
»
USRP RIO
from the palette.
NI-USRP Sample Project
NI-USRP includes a sample project that serves as a starting point to build a USRP RIO
streaming application.
•
LabVIEW NXG 2.1 to Current or LabVIEW Communications System Design Suite 2.1
to Current: From the
Projects
tab, select
USRP RIO
and choose the applicable sample
project for your device and setup.
•
LabVIEW Communications System Design Suite 2.0: From the
Projects
tab, choose the
applicable sample project for your device and setup.
Using Your Device with Software
You can view and manage your device using SystemLink or LabVIEW Communications
System Design Suite.
Note
SystemLink is not supported when using LabVIEW Communications System
Design Suite 2.0.
Related Information
Refer to the SystemLink Manual to learn more about using your device with SystemLink.
USRP-2974 Getting Started Guide
|
© National Instruments
|
5
