•
10 Gb Ethernet network card or 100 Gb Ethernet network card
Tip
NI recommends using an Ethernet network card available in connectivity
kits sold on
www.ettus.com
and
ni.com
.
•
30 dB attenuator
Note
If you directly connect or cable a signal generator to your device, or if you
connect multiple devices together, use an attenuator to avoid damaging the device.
Verifying the System Requirements
To use NI-USRP or UHD, your system must meet certain requirements.
Refer to your driver's readme for more information about minimum system requirements,
recommended system, and supported application development environments (ADEs). The
NI-
USRP Readme
is available online on the driver software download page or at
ni.com/manuals
.
The
UHD Readme
is available on The USRP Hardware Driver Repository.
Ettus USRP X410 Front Panel, Back Panel, and
LEDs
Figure 2. Front Panel
TX/RX 0
TX/RX 0
TX OUTPUT MAX +15 dBm, RX INPUT MAX +20 dBm, ALL RF PORTS 50 Ω
RX 1
RX 1
DB 1
DB 0
RF 0
RF 1
TX/RX 0
TX/RX 0
TX OUTPUT MAX +15 dBm, RX INPUT MAX +20 dBm, ALL RF PORTS 50 Ω
RX 1
RX 1
RF 0
RF 1
GPIO 0
Ettus USRP
X410
3.3 VDC MAX
GPIO 1
3.3 VDC MAX
ESD
SENSITIVE
ESD
SENSITIVE
2-Channel RF
1 MHz to 7.2 GHz
Transceiver
400 MHz BW
2-Channel RF
1 MHz to 7.2 GHz
Transceiver
400 MHz BW
Ettus USRP X410 Getting Started Guide
|
© National Instruments Corporation
|
3
