NuMaker-M256SD
May 20, 2022
Page
39
of 52
Rev 1.00
N
UMA
K
E
R
-M
2
56
S
D
U
S
E
R
MA
N
UA
L
Ma
k
er Nu
-m
be
d
NUC
47
2
Us
er Man
ua
l
4. Figure 4-17 shows the debug mode under IAR EWARN. Click
“
Go
” and the debug message
will be printed out as shown in Figure 4-18. User can debug the project under debug mode by
checking source code, assembly language, peripherals
’ registers, and setting breakpoint, step
run, value monitor, etc.
1 2 3
1. Go
3. Reset
2. Break
Figure 4-17 IAR EWARM Debug Mode
Figure 4-18 Debug Message on Serial Port Terminal Windows
4.6.3
NuEclipse
This section provides steps to beginners on how to run a project by using NuEclipse. Please make sure
the filenames and project folder path contain neither invalid character nor space.
1. Double-click
“NuEclipse.exe" to open the toolchain.
2.
Import the “Template” project by following the steps presented in Figure 4-19 and Figure 4-20.
