Table continued from the previous page...
Parameters
Description
--eir <value>
eir.kbit/s.
--ebs <value>
ebs.octets.
--cf
cf. couple flag.
--cm
cm. color mode.
--dropyellow
drop yellow.
--markred_enable
mark red enable.
--markred
mark red.
qcifmiget
command
--device <ifname>
Interface, such as eth0/sw0p0
--index <value>
Index entry number in this controller. Must have.
qbuset
command
--device <ifname>
Interface, such as eth0/sw0p0
--preemptable <value>
8 bit hex value. Example: 0xfe
The MS bit corresponds to traffic class 7. The LS bit to traffic
class 0.
A bit value of 0 indicates express. A bit value of 1 indicates
preemptable.
cbsset
command
--device <ifname>
Interface, such as eth0/sw0p0
--tc <value>
Traffic class number.
--percentage <value>
Set percentage of tc limitation.
--all <tc-percent:tc-percent...>
Not supported.
cbsget
command
--device <ifname>
Interface, such as eth0/sw0p0
--tc <value>
Traffic class number.
regtool
command
Usage: regtool { pf number } { offset } [ data ]
pf number: pf number for the pci resource to act on
offset : offset into pci memory region to act upon
data : data to be written
ctset
command
--device <ifname>
Interface, such as eth0/sw0p0
Table continues on the next page...
Linux kernel
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
108
NXP Semiconductors
Summary of Contents for Layerscape LS1028A BSP
Page 135: ......
