5 – Detailed Descriptions of Command LineTools
D000006-000 Rev A
5-9
Q
It is recommended that a unique node description be specified for each switch.
This name should follow typical naming rules and use the characters a-z, A-Z,
0-9, and underscore. No spaces are allowed in the node description.
Additionally, names should not start with a digit.
For 9024FC switches, the node GUID can be found on a label on the bottom of
the switch. Alternately, the node GUIDs for switches in the fabric can be found
use a command such as:
saquery -t sw -o nodeguid
NOTE:
The above command will report all switch node GUIDs, including those
of internally-managed chassis such as the 9120 model. GUIDs for
internally-managed chassis cannot be specified for use in
-N
,
IBNODES
,
-L
, or
IBNODES_FILE
specified lists.
5.1.8.2
Explicit Switch names
When switches are explicitly specified via the
-N
option or the
IBNODES
environment variable, a space separated list of GUIDs (optionally with name)
may be supplied. For example:
-N '0x00066a00d9000138,i9k138 0x00066a00d9000139,i9k139'
5.1.9
Selection of local Ports (subnets)
Some of the fabric health commands (
fabric_analysis
,
all_analysis
)
permits a specific set of local HCA ports to be used for fabric analysis. The
default is to use the first active port. However, for IB management nodes
connected to more than 1 IB subnet, it is necessary to specify the local HCA and
port such that the desired subnet will be analyzed. When the non-default
behavior is desired, there are multiple ways to specify the local ports to use:
1. Small sets of ports can be easily specified on the command line via the
-p
option discussed below.
2. When multiple commands will be performed against the same small set of ports,
the environment variable
PORTS
can be used to specify a space separated lists
of ports.
3. For groups of ports that will be used often, a file may be created listing the ports.
The defauilt file is
/etc/sysconfig/iba/ports
that should list all local ports
connected to unique subnets. Such a file may then be specified via the
-t
command line option or the
PORTS_FILE
environment variable.
Within the tools the options that are considered in the following order, the first
item listed below that is specified is used for the given command.
Summary of Contents for Fast Fabric
