Remote Control Commands
R&S
®
NRPxxS(N)
89
User Manual 1177.5079.02 ─ 10
32 | 64
32-bit or 64-bit
If you omit the length, the R&S NRPxxS(N) sets the last used
length.
Example for
REAL,32
format:
#6768000....<binary float values>....
Example for
REAL,64
format:
#71536000....<binary float values>....
<data[,length]>
<ASCii[,0 to 12]>
ASCii
List of comma separated, readable values.
[,0 to 12]
Defines the number of decimal places.
The reset value 0 does not restrict the number of decimal pla-
ces.
Example for
ASCii,4
format:
1.2938e-06, -4.7269e-11, ...
*RST:
ASCii,0
9.6.3
Retrieving Results
After performing the measurement, you can query the measurement results with a
command from the
FETCh
subsystem.
Remote commands:
.............................................................................................89
FETCh<Sensor>:ARRay[:POWer][:AVG]?
.......................................................................... 90
FETCh<Sensor>[:SCALar][:POWer][:AVG]?
........................................................................90
FETCh<Sensor>[:SCALar][:POWer]:BURSt?
...................................................................... 91
FETCh<Sensor>[:SCALar][:POWer]:TSLot?
....................................................................... 91
..............................................................................................92
[SENSe<Sensor>:]FUNCtion
<function>
Sets the measurement mode.
Parameters:
<function>
"POWer:AVG"
Continuous Average
After a trigger event, the power is integrated over a time interval
(averaging) set with
Configuring and Retrieving Results
