Remote Control Commands
R&S
®
SMA100B
433
User Manual 1178.3834.02 ─ 03
Example: Programming Example
// change the phase relative to the current phase
SOURce1:PHASe 2 DEG
// adopt the setting as the current phase
SOURce1:PHASe:REFerence
The following commands are available:
................................................................................ 433
[:SOURce<hw>]:PHASe
<Phase>
Specifies the phase variation relative to the current phase.
Parameters:
<Phase>
float
Range:
-720 to 720
Increment: 0.1
*RST:
0
Default unit: DEG
Example:
See
Manual operation:
See
[:SOURce<hw>]:PHASe:REFerence
Assigns the value set with command
phase.
Example:
See
Usage:
Event
Manual operation:
See
12.15.10 SOURce:POWer Subsystem
The
SOURce:POWer
subsystem contains the commands for setting the output level,
level control and level correction of the RF signal.
The default units are dBm. To change the units, perform on of the following:
●
Enter the unit after the numerical value
Example:
:POW 0.5V
●
Set the unit with the command
[:SOURce<hw>]:POWer:ALC:DSENsitivity
....................................................................... 434
............................................................................. 434
[:SOURce<hw>]:POWer:ALC:SEARch
............................................................................. 435
.............................................................................. 435
[:SOURce<hw>]:POWer:ALC[:STATe]
............................................................................. 435
SOURce Subsystem
