Remote Control Commands
R&S
®
SMA100B
482
User Manual 1178.3834.02 ─ 03
Parameters:
<PTransition>
string
Example:
STAT:QUES:PTR 32767
all transitions from 0 to 1 in the condition part of the STA-
Tus:QUEStionable register cause an entry to be made in the
EVENt part
:STATus:QUEue[:NEXT]?
Queries the oldest entry in the error queue and then deletes it. Positive error numbers
denote device-specific errors, and negative error numbers denote error messages
defined by SCPI. If the error queue is empty, 0 ("No error") is returned.
Return values:
<Next>
string
Example:
:STATus:QUEue?
queries the oldest entry in the error queue.
Response: 0, 'no error'
no errors have occurred since the error queue was last read out
Usage:
Query only
12.18 TEST Subsystem
The
TEST
subsystem contains the commands for performing test routines directly at
the hardware assemblies.
The selftetst responses with a
0
if the test is performed successfully, otherwise a value
other than
0
is returned. None of the commands of this system has a
*RST
value.
................................................................................................482
:TEST<hw>:ALL:STARt
Usage:
Event
Starts the selftest. Use the command
to query the result.
:TEST<hw>:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with
.
Return values:
<Result>
0 | 1 | RUNning | STOPped
*RST:
STOPped
TEST Subsystem
