Remote-Control Commands
R&S
®
SMCVB-K164
82
User Manual 1179.0974.02 ─ 02
********************************************************************************
:SOURce1:BB:T2DVb:INPut:STL:INTerface 1
// Input transport stream for single- or multi-PLP transmission.
********************************************************************************
// Prepare for IP based transport stream
********************************************************************************
:SOURce1:BB:T2DVb:INPut?
// Response: "TS"
:SOURce1:BB:T2DVb:FORMat?
// Response: "ASI"
:SOURce1:BB:INPut IP
:SOURce1:BB:INPut:TSCHannel 2
********************************************************************************
// Query incoming stream properties
********************************************************************************
:SOURce1:BB:T2DVb:INPut:NPLP?
// Response: 1
:SOURce1:BB:T2DVb:INPut:T2MI:ANALyzer?
// Response: "No error"
For configuring IP channel settings and local IP data network parameters, see:
●
●
Chapter 6.10, "BCIP Subsystem"
Commands
[:SOURce<hw>]:BB:T2DVb:SOURce
<Dvbt2Source>
Sets the modulation source for the input signal.
Parameters:
<Dvbt2Source>
EXTernal | TSPLayer | TESTsignal
*RST:
EXTernal
Manual operation:
See
[:SOURce<hw>]:BB:T2DVb:INPut
<Dvbt2Input>
Sets the external input interface.
Parameters:
<Dvbt2Input>
TS | IP
*RST:
TS
Manual operation:
See
[:SOURce<hw>]:BB:T2DVb:INPut:FORMat
<Dvbt2InpFormat>
Sets the input format of the input signal.
Input Commands
