Create a file called wpa_supplicant.conf in the boot partition using the following template.
(This will be moved at boot to the /etc/wpa_supplicant directory). Replace the Country
with yours.
country=US
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1
# RETROPIE CONFIG START
network={
ssid="your_real_wifi_ssid"
psk="your_real_password"
}
# RETROPIE CONFIG END
Make sure to include the RETROPIE CONFIG lines as shown in the Template to ensure that
the RetroPie-Setup wifi configuration module will be able to cleanly edit/delete your
configuration if you wish to change it later.
Hint:
Wifi will not start up if you have an hard wired ethernet connection. After disconnecting
the ethernet cable you'll need to reboot to get Wifi started.
If you want to enable ssh by default as well, you can create a blank file called ssh in the
boot partition too. This is a 'flag' file and will be deleted during boot after ssh is enabled.
When everything is finished, you can unload the Micro-SD Card from your Computer and
put it into your Raspberry Pi.
Summary of Contents for PICADE 3D
