R01UH0823EJ0100 Rev.1.00
Page 476 of 1823
Jul 31, 2019
RX23W Group
23. Multi-Function Timer Pulse Unit 2 (MTU2a)
23.2
Register Descriptions
23.2.1
Timer Control Register (TCR)
x: Don’t care
The MTU has a total of five TCR registers, one each for MTU0 to MTU4.
The TCR register controls the TCNT operation for each channel. The TCR register values should be specified only while
the TCNT operation is stopped.
TPSC[2:0] Bits (Time Prescaler Select)
These bits select the TCNT count clock source. The count clock source can be selected independently for each channel.
Refer to
CKEG[1:0] Bits (Clock Edge Select)
These bits select the clock edge. When the internal clock is counted at both edges, the count clock period is halved (e.g.
PCLK/4 at both edges = PCLK/2 at rising edge). If phase counting mode is used on MTU1 and MTU2, the setting of
these bits is ignored and the phase counting mode setting has priority. Internal clock edge selection is valid when the
count clock source is PCLK/4 or slower. When PCLK/1 or the overflow/underflow in another channel is selected for the
count clock source, a value can be written to these bits but counter operation compiles with the initial value.
CCLR[2:0] Bits (Counter Clear)
These bits select the TCNT counter clearing source. Refer to
Address(es): MTU0.TCR 000D 0B00h, MTU1.TCR 000D 0B80h, MTU2.TCR 000D 0C00h,
MTU3.TCR 000D 0A00h, MTU4.TCR 000D 0A01h
b7
b6
b5
b4
b3
b2
b1
b0
CCLR[2:0]
CKEG[1:0]
TPSC[2:0]
Value after reset:
0
0
0
0
0
0
0
0
Bit
Symbol
Bit Name
Description
R/W
b2 to b0
Time Prescaler Select
Refer to Table 23.6 to Table 23.9.
R/W
b4, b3
Clock Edge Select
b4 b3
0 0: Count at rising edge
0 1: Count at falling edge
1 x: Count at both edges
R/W
b7 to b5
Counter Clear
Refer to Table 23.4 and Table 23.5.
R/W
