replay_interval
Use the
replay_interval
command to configure the DAS replay interval, measured in seconds. The
replay_interval
command is available from the vnsmode:das context.
replay_interval 0-1000
Parameters
0-1000
Specifies the DAS replay interval, measured in seconds.
Examples
The following example sets the DAS replay interval to 60 seconds:
WLC.siemens.com
:vnsmode:das# replay_interval 60
default-role
The
default-role
command moves you into the vnsmode:default-role context. The default-role
replaces the former default-policy of previous releases. The vnsmode:default-role context provides
commands for the configuration of the default-role.
The default-role definitions provide a placeholder for completion of incomplete (no-change) roles
(policies) for the VNS being configured. Refer to
for a complete discussion of role
commands.
The default-role specifies:
•
A topology to use when a VNS is created using a role (non-auth role) that does not specify a
topology. The default assigned topology is the Bridge Traffic Locally at AP topology.
•
An inbound and outbound rate control profile. The default rate control profile is “Unlimited”.
•
A set of filters. The default filter set is a single deny all rule.
After you complete configuration changes for the default-role, run the
apply
command before exiting
the vnsmode:default-role context to implement the changes.
The following commands are available in the vnsmode:default-role context:
•
on page 243
•
on page 244
•
•
on page 245 — See for commands in the vnsmode:default-role:acfilters context.
•
on page 245 — See for commands in the vnsmode:default-role:apfilters context.
show
Use the
show
command to display the default-role configuration information for the current
vnsmode:default-role context. The
show
command is accessible from within the vnsmode:default-role
context.
VNS Commands (vnsmode)
replay_interval
SCALANCE WLC711 CLI Reference Guide
243
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
